Repara tus cosas Comunidad Tienda

RIDGID Belt Sander R2740 Power Cord Replacement

Introducción

If your RIDGID Belt Sander R2740 doesn’t have power the cause could be from a faulty power cord. This guide will teach you how to replace a power cord on a RIDGID Belt Sander R2740 . For this guide, you will need a screwdriver with a T10, T20 and a Phillips #3 head.

Qué necesitas

  1. RIDGID Belt Sander R2740 Power Cord Replacement, Power Cord: paso 1, imagen 1 de 2 RIDGID Belt Sander R2740 Power Cord Replacement, Power Cord: paso 1, imagen 2 de 2

    • Orient the belt sander so that the RIDGID logo is facing you.

    • Remove the six 19 mm and three 51 mm T20 screws that hold the cover into place.

    • Remove the cover from the belt sander.

    • Make sure you remember the correct placement of each screw.

    Editar

  3. RIDGID Belt Sander R2740 Power Cord Replacement: paso 2, imagen 1 de 2 RIDGID Belt Sander R2740 Power Cord Replacement: paso 2, imagen 2 de 2

    • Remove the two 16 mm T10 screws.

    • Remove the support bracket that holds the power cord into place.

    Editar

  4. RIDGID Belt Sander R2740 Power Cord Replacement: paso 3, imagen 1 de 3 RIDGID Belt Sander R2740 Power Cord Replacement: paso 3, imagen 2 de 3 RIDGID Belt Sander R2740 Power Cord Replacement: paso 3, imagen 3 de 3

    • Lift the power cord from the resting grooves.

    • Rotate the switch so that the lock-on button is facing you.

    • Loosen the two 8 mm Phillips #3 screws.

    • Pull the two wires away from the switch.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 9

Todo El Tiempo: 637