Saltar al contenido principal

Introducción

This replacement guide will teach you how to replace a worn speaker. This will ensure the device has quality sound. If the speaker has not fixed the issue there may be an electrical shortage in the device.

  1. Push down on the clip to release pressure. The pull off the plastic cover. Push down on the clip to release pressure. The pull off the plastic cover.
    • Push down on the clip to release pressure. The pull off the plastic cover.

  2. Remove  the 9-volt battery from the battery terminal.
    • Remove the 9-volt battery from the battery terminal.

  3. Take out the six screws located on the back of the device.
    • Take out the six screws located on the back of the device.

    • The red screws are 10 mm Phillip's #1. The orange screws are 13 mm Phillips #1.

    • Three screws are located on the back panel. One is located inside the battery carriage.

    • Two screws are located on the on the back panel on the bottom left and right side.

  4. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  5. Remove the 10 mm Phillip's #1 screw. Then remove the metal reinforcement. Then remove the metal reinforcement.
    • Remove the 10 mm Phillip's #1 screw.

    • Then remove the metal reinforcement.

  6. Using flathead screwdriver undo the release tabs. Using flathead screwdriver undo the release tabs.
    • Using flathead screwdriver undo the release tabs.

  7. Pry the release tabs with a spudger. Start with back of the device on the topside. Start with back of the device on the topside.
    • Pry the release tabs with a spudger.

    • Start with back of the device on the topside.

  8. Pry open both tabs to remove the topside of the clock. Pry open both tabs to remove the topside of the clock.
    • Pry open both tabs to remove the topside of the clock.

  9. Remove the two 10mm Phillip's #1 screws. Also remove the two reinforcements holding the speaker in place.
    • Remove the two 10mm Phillip's #1 screws. Also remove the two reinforcements holding the speaker in place.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Myles Waiters

Miembro Desde 22/09/14

337 Reputación

3 Guías creadas

Equipo

USF Tampa, Team 10-5, Brown Fall 2014 Miembro de USF Tampa, Team 10-5, Brown Fall 2014

USFT-BROWN-F14S10G5

3 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 100