Introducción

Use this guide to replace the USB port of the RCA Lyra X2400.

Remove two Phillips screws from the silver cover at the top of the Lyra.
  • Remove two Phillips screws from the silver cover at the top of the Lyra.

  • Slowly wiggle the silver cover while pulling it away from the device.

Agregar Comentario

Remove two Phillips screws from the bottom of the device, next to the charger port and Compact Flash release button.
  • Remove two Phillips screws from the bottom of the device, next to the charger port and Compact Flash release button.

  • Pull the silver case from the bottom of the device.

Agregar Comentario

  • Carefully pry up the screen with a plastic opening tool.

  • Disconnect the screen's ribbon cable from the circuit board.

  • Remove the screen.

Agregar Comentario

  • Open the case of the Lyra.

  • Remove the four screws that secure the motherboard to the frame of the Lyra X2400.

Agregar Comentario

  • Locate the USB in/out component on your Lyra X2400. If you are having difficulty locating this component the picture to the left will show you where it is located.

  • Start using solder/desolder tools to remove the USB in/out.

  • Once removed replace it with the new working USB in/out.

    • Use the soldering tools to reattach the component back to the main logic board.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Joseph Goodwin

Miembro Desde 11/04/13

1 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 17-3, Regan Spring 2013 Miembro de Cal Poly, Team 17-3, Regan Spring 2013

CPSU-REGAN-S13S17G3

4 Miembros

8 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 3

Todo El Tiempo: 142