Introducción

This guide will show in detail the necessary steps to safely remove the main motherboard from your RCA Lyra X2400 for full/partial replacement and/or general troubleshooting.

Partes

No se requieren partes.

  1. Using slight pressure with your finger on the word "OPEN", slide the battery plate down.
    • Using slight pressure with your finger on the word "OPEN", slide the battery plate down.

    • Remove the battery plate.

    • Place your finger at the bottom of the battery.

    • Lift up on the battery until it pops out from the LYRA X2400.

    Agregar Comentario

  2. Remove two Phillips screws from the silver cover at the top of the Lyra.
    • Remove two Phillips screws from the silver cover at the top of the Lyra.

    • Slowly wiggle the silver cover while pulling it away from the device.

    Agregar Comentario

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove two Phillips screws from the bottom of the device, next to the charger port and Compact Flash release button.

    • Pull the silver case from the bottom of the device.

    Agregar Comentario

    • Carefully pry up the screen with a plastic opening tool.

    • Disconnect the screen's ribbon cable from the circuit board.

    • Remove the screen.

    Agregar Comentario

    • Open the case of the Lyra.

    • Remove the four screws that secure the motherboard to the frame of the Lyra X2400.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Evan Lindquist

Miembro Desde 11/04/13

1 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 17-3, Regan Spring 2013 Miembro de Cal Poly, Team 17-3, Regan Spring 2013

CPSU-REGAN-S13S17G3

4 Miembros

8 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 258