Introducción

This guide will instruct you to replace the onboard microphone if it is faulty.

Lift the metal flap and slide  the viewfinder off to the right.
  • Lift the metal flap and slide the viewfinder off to the right.

Agregar Comentario

Unscrew the 7.0mm ph#0 screw on the underside where the cable connects.
  • Unscrew the 7.0mm ph#0 screw on the underside where the cable connects.

  • Lift the plastic where the cable is connected to the viewfinder.

  • Disconnect the cable inside by pulling it apart.

Agregar Comentario

  • Unscrew the two 7mm ph#0 screws on the underside of the viewfinder assembly.

  • Lift the viewfinder plastic assembly up.

Agregar Comentario

  • Lift the microphone circuit board straight up.

  • Unclip the cable connected to the circuit board.

Agregar Comentario

  • Turn the microphone circuit board over.

  • Unscrew the two Ph#0 screws holding the plastic housing on the circuit board.

Agregar Comentario

  • Desolder the metal protective housing using a soldering iron.

  • Desolder the microphone and replace it.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Oliver Adams

Miembro Desde 19/01/11

620 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 5-20, Amido Winter 2011 Miembro de Cal Poly, Team 5-20, Amido Winter 2011

CPSU-AMIDO-W11S5G20

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 691