Repara tus cosas Comunidad Tienda

Quantum View 10.1 camera Replacement

Qué necesitas

  1. Quantum View 10.1 camera Replacement, Open Quantum View case: paso 1, imagen 1 de 1

    • Start by turning the tablet over with the screen down. Carefully use a plastic opening tool to pry the cover off. Start from the corner opposite the hibernate button.

    Editar

  2. Quantum View 10.1 camera Replacement, Removing the electrical tape and magnets.: paso 2, imagen 1 de 2 Quantum View 10.1 camera Replacement, Removing the electrical tape and magnets.: paso 2, imagen 2 de 2

    • Pick up the magnets from the bottom edge of the tablet next to the keyboard connection and put them in a place that they will not get lost. Then carefully remove all 4 strips of electrical tape.

    Editar

  4. Quantum View 10.1 camera Replacement, Unhooking the battery: paso 3, imagen 1 de 2 Quantum View 10.1 camera Replacement, Unhooking the battery: paso 3, imagen 2 de 2

    • Using a small plastic opening tool; genteelly pull the connection off of the motherboard.

    Editar

    • Remove yellow plastic and carefully pull clip away from connection.

    Editar

  6. Quantum View 10.1 camera Replacement, Remove camera clip: paso 5, imagen 1 de 2 Quantum View 10.1 camera Replacement, Remove camera clip: paso 5, imagen 2 de 2

    • Remove yellow tape.

    • Unclip ribbon connector.

    Editar

  7. Quantum View 10.1 camera Replacement, Remove camera: paso 6, imagen 1 de 2 Quantum View 10.1 camera Replacement, Remove camera: paso 6, imagen 2 de 2

    • Unscrew plastic camera holder using a PH00 screwdriver bit.

    • Release the plastic holder tab and remove camera.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 3

Todo El Tiempo: 148