Repara tus cosas Comunidad Tienda

QFX IT-437 Motherboard Replacement

Qué necesitas

  1. QFX IT-437 Motherboard Replacement, Motherboard: paso 1, imagen 1 de 1

    • Begin the process by using a PH00 Phillips screw driver.

    • Remove the two 1.2mm x 3mm screws at the bottom of the tablet.

    Editar

  2. QFX IT-437 Motherboard Replacement: paso 2, imagen 1 de 2 QFX IT-437 Motherboard Replacement: paso 2, imagen 2 de 2

    • Use the iFixit plastic opening tool to pry open the back of the tablet.

    • Do not remove the back case completely as tape has to be removed from the wires, and pulling the case apart can tear off the wires.

    Editar

  3. QFX IT-437 Motherboard Replacement: paso 3, imagen 1 de 1

    • In order to unseat the motherboard, use the Phillips PH00 screw driver bit to remove the three 1.2mm x 3mm screws.

    Editar

  5. QFX IT-437 Motherboard Replacement: paso 4, imagen 1 de 1

    • Once the motherboard is loose, remove the tape above the SD card slot using an iFixit opening pick.

    • Be careful not to rip or damage the tape or else new tape will have to be used for the new motherboard.

    Editar

  6. QFX IT-437 Motherboard Replacement: paso 5, imagen 1 de 1

    • Use the spudger to remove the ribbon.

    • Avoid using too much force here or else the ribbon can be ripped.

    Editar

  7. QFX IT-437 Motherboard Replacement: paso 6, imagen 1 de 1

    • Use the spudger in the top corner of the tablet and lift the camera up.

    Editar

  8. QFX IT-437 Motherboard Replacement: paso 7, imagen 1 de 1

    • Lift the tape over the wires that are holding them to the tablet insulation.

    Editar

  9. QFX IT-437 Motherboard Replacement: paso 8, imagen 1 de 1

    • Pull out the motherboard and set it aside.

    • The wires must be soldered back on to the motherboard.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Douglas

Miembro Desde 01/28/15

482 Reputación

4 Guías creadas

Insignias: 6

+ 3 más insignias

Equipo

Pasco Hernando, Team 5-2, Prince Winter 2015 Miembro de Pasco Hernando, Team 5-2, Prince Winter 2015

PHSC-PRINCE-W15S5G2

6 Miembros

8 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 3

Todo El Tiempo: 229