Saltar al contenido principal
  1. Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component. Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
    • Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.

  2. Remove the 1.2 cm hex T9 screws and gently open up the device. Remove the 1.2 cm hex T9 screws and gently open up the device.
    • Remove the 1.2 cm hex T9 screws and gently open up the device.

  3. Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard. Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard.
    • Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard.

  4. Use a plastic spudger to push the black sliding cable connector away from the white bracket. Use a plastic spudger to push the black sliding cable connector away from the white bracket.
    • Use a plastic spudger to push the black sliding cable connector away from the white bracket.

  5. Gently remove the ribbon cable from the connector.
    • Gently remove the ribbon cable from the connector.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 82