Repara tus cosas Comunidad Tienda

Protocol Vento Motor Replacement

Introducción

The Protocol Vento drone has four motors. Each motor is located at the base of one of the drone's four arms. This guide will demonstrate how to remove and replace a motor.

Qué necesitas

  1. Protocol Vento Motor Replacement, Battery: paso 1, imagen 1 de 1

    • Grasp the tail end of the drone where the lip of the battery protrudes.

    Editar

  2. Protocol Vento Motor Replacement: paso 2, imagen 1 de 1

    • Pull away from the drone to remove the battery.

    • Do not attempt any repairs or replacements before removing the battery from the drone.

    Editar

  3. Protocol Vento Motor Replacement, Propeller: paso 3, imagen 1 de 1

    • Place a prying tool under the base of the propeller.

    Editar

  5. Protocol Vento Motor Replacement: paso 4, imagen 1 de 2 Protocol Vento Motor Replacement: paso 4, imagen 2 de 2

    • Use a moderate amount of force to pry the propeller out of its base. The propeller should pop off.

    Editar

  6. Protocol Vento Motor Replacement, Motor: paso 5, imagen 1 de 1

    • Unscrew the 4.9mm Phillips #000 screw that is located at the end of the drone's arm.

    Editar

  7. Protocol Vento Motor Replacement: paso 6, imagen 1 de 2 Protocol Vento Motor Replacement: paso 6, imagen 2 de 2

    • Hold the base of the arm while gently pulling the motor cover away from the arm.

    • Do not pull too hard because there are wires attaching the motor to the drone. Do not sever the wires.

    Editar

  8. Protocol Vento Motor Replacement: paso 7, imagen 1 de 2 Protocol Vento Motor Replacement: paso 7, imagen 2 de 2

    • Gently pull the motor out from the plastic cover.

    • Do not squeeze or pull too hard, as to not damage the motor connection.

    Editar

  9. Protocol Vento Motor Replacement: paso 8, imagen 1 de 2 Protocol Vento Motor Replacement: paso 8, imagen 2 de 2

    • The motor’s blue and red wires are secured via a white clip. This clip is inserted into a slot in the drone’s leg.

    • Grasp the clip’s edges with a pair of tweezers and pull outward.

    • Do not pull directly on the wires, as to not separate the wires from the clip.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Maria Larcomb

Miembro Desde 02/15/18

926 Reputación

5 Guías creadas

Insignias: 18

+ 15 más insignias

Equipo

USF Tampa, Team S1-G2, Leahy Spring 2018 Miembro de USF Tampa, Team S1-G2, Leahy Spring 2018

USFT-LEAHY-S18S1G2

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 5

Ultimos 30 días: 10

Todo El Tiempo: 652