Repara tus cosas Comunidad Tienda

Protocol TerraCopter EVO Drone Motor Replacement

Qué necesitas

  1. Protocol TerraCopter EVO Drone Motor Replacement, Drone Motor: paso 1, imagen 1 de 1

    • Orientate the drone to where the black side of the drone face upwards.

    • On the bottom side of the drone, remove the twenty-two 5mm Phillips #1 screws holding the black frame to the body.

    • There is one screw under the rear light. Pry the opaque cover to access the last screw.

    Editar

  2. Protocol TerraCopter EVO Drone Motor Replacement: paso 2, imagen 1 de 1

    • The plastic frames are subject to cracking.

    • Wires run through both frames.

    • Pry the white body away from the black frame.

    Editar

  4. Protocol TerraCopter EVO Drone Motor Replacement: paso 3, imagen 1 de 1

    • Gently pry the motor from it's socket.

    Editar

  5. Protocol TerraCopter EVO Drone Motor Replacement: paso 4, imagen 1 de 2 Protocol TerraCopter EVO Drone Motor Replacement: paso 4, imagen 2 de 2

    • Locate these solder points of the leads on the motherboard.

    • From the front of the drone, the left motor has red and blue leads.

    • From the front of the drone, the right motor has white and black leads.

    • Remove the leads from their points on the motherboard with a soldering iron, respective to each motor.

    • Check out our How to Solder and Desolder Connections guide if you are unfamiliar with soldering practices.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 3

Todo El Tiempo: 202