Repara tus cosas Comunidad Tienda

Protocol Slipstream EVO Propeller Guards Replacement

Qué necesitas

  1. Protocol Slipstream EVO Propeller Guards Replacement, Propeller Guards: paso 1, imagen 1 de 1

    • With the drone flat on the ground, identify which propeller guard you will be replacing.

    • The front of the drone is where there are no wires exposed.

    Editar

  3. Protocol Slipstream EVO Propeller Guards Replacement: paso 2, imagen 1 de 2 Protocol Slipstream EVO Propeller Guards Replacement: paso 2, imagen 2 de 2

    • With the plastic opening tool, pry the side of the guard closest to the front or the back of the drone depending on where you decided to start from.

    • After prying off one side of the guard, pushing down on the same side will release the other side of the clip.

    • Repeat this step for the following side as needed.

    Editar

  4. Protocol Slipstream EVO Propeller Guards Replacement: paso 3, imagen 1 de 2 Protocol Slipstream EVO Propeller Guards Replacement: paso 3, imagen 2 de 2

    • With the replacement guard line up the clips and push the clips into place.

    • After the guard has been attached to the drone, pinch the clips as you push the guards to ensure they are secured.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 4 otros colaboradores

Michael Dang

Miembro Desde 04/10/17

301 Reputación

3 Guías creadas

Insignias: 3

Equipo

UW Tacoma, Team S3-G3, Liner Spring 2017 Miembro de UW Tacoma, Team S3-G3, Liner Spring 2017

UWT-LINER-S17S3G3

4 Miembros

3 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 7

Todo El Tiempo: 151