Repara tus cosas Comunidad Tienda

Protocol Neo-Drone AP Motor Replacement

Introducción

This guide shows you how to replace the motors on your drone. Soldering is a skill required for this task. Replacement motors can be found on the manufacturer's website.

Qué necesitas

  1. Protocol Neo-Drone AP Motor Replacement, Motor: paso 1, imagen 1 de 2 Protocol Neo-Drone AP Motor Replacement, Motor: paso 1, imagen 2 de 2

    • Remove the four blades by pulling them off of the motors.

    Editar

  2. Protocol Neo-Drone AP Motor Replacement: paso 2, imagen 1 de 1

    • Remove the blade guards by pushing the guards downward towards the padded feet.

    Editar

  4. Protocol Neo-Drone AP Motor Replacement: paso 3, imagen 1 de 1

    • Remove the four 4.5mm Phillips #0 screws from the back panel.

    Editar

  5. Protocol Neo-Drone AP Motor Replacement: paso 4, imagen 1 de 2 Protocol Neo-Drone AP Motor Replacement: paso 4, imagen 2 de 2

    • Use the flat end of a spudger to pry apart the the two pieces.

    • Lift the back panel up to separate it from the front panel.

    Editar

  6. Protocol Neo-Drone AP Motor Replacement: paso 5, imagen 1 de 1

    • Pull the four motors out of the case.

    • The motors are still soldered to the motherboard.

    Editar

  7. Protocol Neo-Drone AP Motor Replacement: paso 6, imagen 1 de 1

    • Here is a link to the iFixit Soldering Guide

    • Use a soldering iron to desolder the motors from the motherboard.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 4 otros colaboradores

Andrew

Miembro Desde 07/05/18

291 Reputación

2 Guías creadas

Insignias: 5

+ 2 más insignias

Equipo

IUPUI, Team S2-G3, Harley Summer 2018 Miembro de IUPUI, Team S2-G3, Harley Summer 2018

IUPUI-HARLEY-SU18S2G3

4 Miembros

2 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 397