Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.
Introducción
This guide will walk you through how remove the drone motors from the lower housing. Minimal tooling is required; however, prerequisite steps are required. This guide is useful for replacing a motor that may be defective or damaged.
i use atten soldering station
Qué necesitas
-
-
-
Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.
-
-
-
Remove the 3 outer 8mm long Phillips #0 screws from the lower drone housing.
-
Remove the 2 inner 3 mm long Phillips #0 screws from the drone motor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.