Protocol Dronium Two Blade Guard Replacement

Introducción

This guide shows how to remove the blade guard on the Protocol Dronium Two. The only tool you will need is the #0 Phillips screwdriver. The screwdriver is also included in the box of your drone. Perform this repair in a clean and well lit area so that you don't lose the screw.

Qué necesitas

Paso 1 Blade Guard

Protocol Dronium Two Blade Guard Replacement, Blade Guard: paso 1, imagen 1 de 1

Turn the drone off by moving the selector switch to the left.

Editar

Paso 2

Using your screwdriver, remove the 8.36mm Phillips screw.

Editar

Paso 3

While holding the drone with one hand, gently lift the blade guard straight up and remove it.
Be careful not to break off the two studs holding the blade guard in place.

Editar