Saltar al contenido principal

Prerequisite Only

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. Prerequisite Only, Prerequisite Only: paso 1, imagen 1 de 1
    • Find the grooves around the buttons on the front and carefully remove the panel. This can be done without the use of any tools.

  2. Prerequisite Only: paso 2, imagen 1 de 1
    • Using a plastic opening tool, place the skinny flat end between the groove running along side of the device.

    • Using a twisting motion, detach the control panel from the device

  3. Prerequisite Only: paso 3, imagen 1 de 1
    • Find the groove around the outside of the green section. Use an ESD safe spudger to slowly lift the plastic panel up.

  4. Prerequisite Only: paso 4, imagen 1 de 2 Prerequisite Only: paso 4, imagen 2 de 2
    • After removing the green section, find the groove around the display. Insert a ESD safe spudger and carefully lift the display.

  5. Prerequisite Only: paso 5, imagen 1 de 1
    • The display can lift up the display but be sure not to damage any of the cables connecting it to the mother board.

    • Remove the screw located under the display using the 00 Phillips head screwdriver.

  6. Prerequisite Only: paso 6, imagen 1 de 3 Prerequisite Only: paso 6, imagen 2 de 3 Prerequisite Only: paso 6, imagen 3 de 3
    • Pull up on the motherboard and display. It is glued to the base so it will require a little force. Be careful though, as the board is fragile.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Joshua Meines

Miembro Desde 10/19/16

316 Reputación

3 Guías creadas

Equipo

IUPUI, Team 2-5, Baechle Fall 2016 Miembro de IUPUI, Team 2-5, Baechle Fall 2016

IUPUI-BAECHLE-F16S2G5

4 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 46