Saltar al contenido principal

Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.

Qué necesitas

  1. , Bateria: paso 1, imagen 1 de 2 , Bateria: paso 1, imagen 2 de 2
    • Ubique la lengüeta de liberación de la batería en la parte inferior del G4.

    • Deslice la lengüeta de liberación de la batería hacia la izquierda y levante la batería de la computadora.

  2. Este paso está sin traducir. Ayuda a traducirlo

    : paso 2, imagen 1 de 2 : paso 2, imagen 2 de 2
    • Remove the seven T8 Torx screws from the lower case.

    • Using your thumbs, slide the lower case toward the front of the computer.

    • The lower case may stick in the front on a tab just above the center of the optical drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.

    • Lift the lower case off.

  3. Este paso está sin traducir. Ayuda a traducirlo

    : paso 3, imagen 1 de 1
    • Disconnect the orange optical drive, modem and inverter cables from the logic board, removing tape as necessary.

    • Disconnect the two-wire pink and white inverter cable from the inverter board.

  4. Este paso está sin traducir. Ayuda a traducirlo

    : paso 4, imagen 1 de 1
    • Lift of the right side of the optical drive and disconnect the modem cable.

  5. Este paso está sin traducir. Ayuda a traducirlo

    : paso 5, imagen 1 de 1
    • Lift the optical drive up and out of the computer.

  6. Este paso está sin traducir. Ayuda a traducirlo

    : paso 6, imagen 1 de 1
    • Disconnect the multicolor cable from the PRAM battery.

  7. Este paso está sin traducir. Ayuda a traducirlo

    : paso 7, imagen 1 de 1
    • Use a spudger to pry the PRAM battery out of its housing on the upper case. Make sure not to bend the PRAM battery too much while prying it out.

Linea de Meta

12 personas más completaron esta guía.

Documentos Adjuntos

iRobot

Miembro Desde 09/24/09

1 Reputación

636 Guías creadas

2 comentarios

Thanks..

Great instructions.

Now to find a M6091 main battery.

does a lubricant help reduce the tension on the screen mounts. ? I read these easily break.

andrew - Contestar

I lubricated my screen hinges some years ago. It did help, but I should probably do it again. I think I used a very thin silicone or aromatics WD-40 type of spray, and carefully attempted to pry open the gap of the hinge to facilitate the ingress of the lube, maybe using an Opinel knife or a Stanley blade. Apologies for flaky memory. My hinges are still a dangerously weak point, and I always open the laptop carefully and slowly with two hands. Good luck.

sqeeezy -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 22

Ultimos 30 días: 59

Todo El Tiempo: 25,645