Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove both expansion bay modules using the levers on the front of the computer.
-
Insert your index fingers inside the expansion bays and search for the two ribbed tabs on the underside of the upper case. The tabs are located near the bottom corners of the keyboard.
-
Pull the tabs toward yourself and the keyboard will pop up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the keyboard forward to disengage the tabs holding it in back and rotate it toward you.
-
Rest the keyboard on the trackpad.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
1) With your fingernails, grasp the locking bar on either side and pull up a small amount (about 1/16" or 2 mm).
-
2) After disengaging the locking bar, slide the cable out of the connector.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the two keyboard connectors by disengaging the clamps and pulling the ribbons directly upward.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide a spudger downward between each plastic strain relief cable and the wall of the case in order to bow out the cable beyond the small tab holding it in place.
-
Once the strain relief cables are free, lift the keyboard off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two Phillips screws from the heat shield.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grasp the metal handle on the heat shield and pull up and toward yourself.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.