Saltar al contenido principal

Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.

Qué necesitas

  1. , Panel lateral: paso 1, imagen 1 de 1
    • Para evitar electrocutarse, apaga el ordenador. No abras el ordenador o intentar instalar algún dispositivo mientras el ordenador está encendido

    • Para evitar quemarse, espera al menos 10 minutos para dejar a los componentes del ordenador enfriar.

  2. : paso 2, imagen 1 de 1
    • Quita todos los cables, incluido los de alimentación antes de abrir la unidad.

  3. : paso 3, imagen 1 de 2 : paso 3, imagen 2 de 2
    • Levanta la palanca para desenganchar el panel lateral.

    • El panel caerá. Si el panel no cae por ella sola tira un poco de las esquinas.

  4. : paso 4, imagen 1 de 3 : paso 4, imagen 2 de 3 : paso 4, imagen 3 de 3
    • Quita el deflector de aire (el plastico transparente) tirando de la palanca.

  5. Este paso está sin traducir. Ayuda a traducirlo

    : paso 5, imagen 1 de 1
    • Locate the front fan assembly.

  6. Este paso está sin traducir. Ayuda a traducirlo

    : paso 6, imagen 1 de 1
    • Pull the fan assembly out; it should slide out easily.

  7. Este paso está sin traducir. Ayuda a traducirlo

    : paso 7, imagen 1 de 1
    • Locate the RAM on the Power Mac G5.

  8. Este paso está sin traducir. Ayuda a traducirlo

    : paso 8, imagen 1 de 3 : paso 8, imagen 2 de 3 : paso 8, imagen 3 de 3
    • Use your thumbs to push the RAM ejector pins to the sides.

    • The RAM module should pop up slightly.

  9. Este paso está sin traducir. Ayuda a traducirlo

    : paso 9, imagen 1 de 1
    • Remove the RAM module from the DIMM slot.

    • The RAM modules must be installed in pairs, with one module per bank (top and bottom).

    • When reinstalling the RAM, make sure to note the notch on the DIMM slot. This notch needs to line up with the corresponding gap on the RAM module.

Linea de Meta

60 personas más completaron esta guía.

Salvador Aguilar

Miembro Desde 01/21/10

2,481 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 5-8, Forte Winter 2010 Miembro de Cal Poly, Team 5-8, Forte Winter 2010

CPSU-FORTE-W10S5G8

7 Miembros

20 Guías creadas

2 comentarios

Major thing to note, you must install RAM in pairs. You can't just install one card on the top and not one on the bottom. Pairs start from the center and move outwards.

Red Rabbit 90 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 6

Ultimos 30 días: 52

Todo El Tiempo: 40,228