Introducción

This guide will show you how to remove and replace the Video Adapter in your Power Mac 4 Quicksilver.

Partes

No se requieren partes.

  1. The handle to open your computer is located on top of the right side panel.
    • The handle to open your computer is located on top of the right side panel.

    Agregar Comentario

  2. Grab the circular handle and pull outward.
    • Grab the circular handle and pull outward.

    Agregar Comentario

    • Your computer is now open and ready for repair.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • This is your Power Mac G4's video adapter.

    Agregar Comentario

    • Start by removing the screw holding the card to the chassis as shown.

    Agregar Comentario

    • Before lifting the card out, this small plastic tab needs to be pulled back there by releasing it entirely.

    Agregar Comentario

    • With the tab and screw removed, lift the card straight out.

    • When putting the card back in, take care to apply even pressure across the top with your thumbs. This will avoid damaging the card.

    Agregar Comentario

    • Your card is now completely removed and ready to be replaced.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Equipo

Cal Poly, Team 14-41, Regan Winter 2010 Miembro de Cal Poly, Team 14-41, Regan Winter 2010

CPSU-REGAN-W10S14G41

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 8

Todo El Tiempo: 6,436