Saltar al contenido principal

Introducción

Installing Modem involves removing the outer case and video card before installation.

Partes

No se especificaron partes.

  1. Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case. Push back the handle after you have taken the core out of the case. Push back the handle after you have taken the core out of the case.
    • Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.

    • Push back the handle after you have taken the core out of the case.

  2. Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side. Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.
    • Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.

  3. Slowly lift the plate off the cube and disconnect the power cord.
    • Slowly lift the plate off the cube and disconnect the power cord.

  4. Remove the four pillars from each corner.
    • Remove the four pillars from each corner.

    • The pillars should come out fairly easily.

  5. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  6. Remove the screws on the back of the VGA port.
    • Remove the screws on the back of the VGA port.

  7. Remove the screw attaching the video card to the logic board.
    • Remove the screw attaching the video card to the logic board.

  8. Remove power cord from the video card. Remove power cord from the video card.
    • Remove power cord from the video card.

  9. Remove the power cord.
    • Remove the power cord.

    • Remove the connector.

    • Remove the video card from the logic board.

  10. Carefully lift the video card from the logic board.
    • Carefully lift the video card from the logic board.

    • The video card should come out easily.

  11. Separate the video card from the adapter. Separate the video card from the adapter.
    • Separate the video card from the adapter.

  12. Remove the two screws from the modem.
    • Remove the two screws from the modem.

  13. Lift modem from the Logic Board.
    • Lift modem from the Logic Board.

    • The modem should come out easily.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Ryan Chun

Miembro Desde 24/06/10

701 Reputación

7 Guías creadas

Equipo

Cal Poly, Team 2-7, Johann Summer 2010 Miembro de Cal Poly, Team 2-7, Johann Summer 2010

CPSU-JOHANN-R10S2G7

5 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 5

Todo El Tiempo: 3,683