Repara tus cosas

Derecho a reparar

Tienda

Polaroid Sun 600 LMS Lens Replacement

Escrito Por: Ian Hosek (y 5 de otros participantes)
  • Comentarios: 1
  • Favoritos: 48
  • Terminaciones: 2

Dificultad

Fácil

Pasos

6

Tiempo Requerido

10 minutos

Secciones

1

Banderas

0

Introducción

Replacing a broken or scratched lens on a Polaroid Sun 600 LMS.

  1. Move film door slide on the left side of camera forward. Pull film door open.

    • Move film door slide on the left side of camera forward.

    • Pull film door open.

    Editar

  2. Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place. If your camera is old or dirty, it may take more force to open the flash assembly.

    • Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.

    • If your camera is old or dirty, it may take more force to open the flash assembly.

    Editar

  4. Use a spudger on each side to separate the flash segment from the main body. Be careful not to do this too hard because you may pull out the connecting wires.

    • Use a spudger on each side to separate the flash segment from the main body.

    • Be careful not to do this too hard because you may pull out the connecting wires.

    Editar

  5. Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame. Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame.

    • Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame.

    Editar

  6. Place left hand on the gray section and right hand on the black section. Pull the sections apart.

    • Place left hand on the gray section and right hand on the black section.

    • Pull the sections apart.

    Editar

  7. Carefully remove the damaged lens from the interior of the camera. Replace with a new lens.

    • Carefully remove the damaged lens from the interior of the camera.

    • Replace with a new lens.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 5 otros colaboradores

Ian Hosek

Miembro Desde 20/01/10

375 Reputación

1 Guía escrita

Insignias: 9

+ 6 más insignias

Equipo

Cal Poly, Team 3-18, Maness Winter 2010 Miembro de Cal Poly, Team 3-18, Maness Winter 2010

CPSU-MANESS-W10S3G18

4 Miembros

4 Guías creadas

0 comentarios

Agregar un comentario

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 11

Ultimos 30 días: 43

Todo El Tiempo: 8,706