Introducción

Replacing a broken or scratched lens on a Polaroid Sun 600 LMS.

Move film door slide on the left side of camera forward.
  • Move film door slide on the left side of camera forward.

  • Pull film door open.

Agregar Comentario

Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.
  • Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.

  • If your camera is old or dirty, it may take more force to open the flash assembly.

Agregar Comentario

  • Use a spudger on each side to separate the flash segment from the main body.

  • Be careful not to do this too hard because you may pull out the connecting wires.

Agregar Comentario

  • Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame.

Agregar Comentario

  • Place left hand on the gray section and right hand on the black section.

  • Pull the sections apart.

Agregar Comentario

  • Carefully remove the damaged lens from the interior of the camera.

  • Replace with a new lens.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Ian Hosek

Miembro Desde 20/01/10

345 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 3-18, Maness Winter 2010 Miembro de Cal Poly, Team 3-18, Maness Winter 2010

CPSU-MANESS-W10S3G18

4 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 6

Últimos 30 Días: 32

Todo El Tiempo: 7,710