Saltar al contenido principal

Plugging in Shure SM58 XLR Cable

  1. Plugging in Shure SM58 XLR Cable, XLR Cable Plug In: paso 1, imagen 1 de 1
    • Make sure you have a proper three pin XLR cable.

    • Grab the female end of the cable (plug with three holes).

  2. Plugging in Shure SM58 XLR Cable: paso 2, imagen 1 de 1
    • Line up the pins in the end of the microphone (microphone connecter) with the holes in the XLR cable.

  3. Plugging in Shure SM58 XLR Cable: paso 3, imagen 1 de 1
    • Once the pins are aligned, push the cable into the bottom end of the microphone. You should hear a click.

Conclusión

To disconnect the cable from the microphone, follow the instructions in reverse.

13 personas más completaron esta guía.

nat coll

Miembro Desde 09/27/12

642 Reputación

14 Guías creadas

Equipo

Cal Poly, Team 7-53, Forte Fall 2012 Miembro de Cal Poly, Team 7-53, Forte Fall 2012

CPSU-FORTE-F12S7G53

5 Miembros

20 Guías creadas

21 comentarios

When disconnecting the cable - press the little latch (pointing towards you in the last picture) to release and then pull the cable out.

harrywwc - Contestar

Is this April's fool? XD

s6963172 - Contestar

how i repair the PG48 the XLR conector moves in and out when the cable ar plugged. The conector male in the microphone have an screw but that one not works...

What am i do?

If you have an idea to the answer or any tip to resolve this trouble feel fre to tweet me.

@ Theradioholic

on

#Twitter

Santiago Morales - Contestar

I know a few people who would see this and still screw it up.

jimboc - Contestar

do it in reverse? you have to press the button though on the male end...

Michael Fox - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 7

Ultimos 7 días: 31

Ultimos 30 días: 131

Todo El Tiempo: 67,407