Repara tus cosas Comunidad Tienda

PlayStation 2 Slimline IR Sensor Replacement

Introducción

This guide will show you how to locate and replace the Infrared Sensor in the Playstation 2 Slimline. The IR sensor reads wireless signals so PS2 controllers and remotes function as if they were plugged into the unit.

Qué necesitas

  1. PlayStation 2 Slimline IR Sensor Replacement, Outer Shell: paso 1, imagen 1 de 1

    • Disconnect all cables from the console and flip the unit over to reveal its base.

    Traducir

  2. PlayStation 2 Slimline IR Sensor Replacement: paso 2, imagen 1 de 3 PlayStation 2 Slimline IR Sensor Replacement: paso 2, imagen 2 de 3 PlayStation 2 Slimline IR Sensor Replacement: paso 2, imagen 3 de 3

    • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

    • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

    Traducir

  3. PlayStation 2 Slimline IR Sensor Replacement: paso 3, imagen 1 de 3 PlayStation 2 Slimline IR Sensor Replacement: paso 3, imagen 2 de 3 PlayStation 2 Slimline IR Sensor Replacement: paso 3, imagen 3 de 3

    • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

    Traducir

  5. PlayStation 2 Slimline IR Sensor Replacement: paso 4, imagen 1 de 3 PlayStation 2 Slimline IR Sensor Replacement: paso 4, imagen 2 de 3 PlayStation 2 Slimline IR Sensor Replacement: paso 4, imagen 3 de 3

    • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

    • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

    Traducir

  6. PlayStation 2 Slimline IR Sensor Replacement, IR Sensor: paso 5, imagen 1 de 1

    • Locate the IR sensor at the front, right corner of the unit.

    Traducir

  7. PlayStation 2 Slimline IR Sensor Replacement: paso 6, imagen 1 de 1

    • Gently detach the ribbon cable connecting the IR sensor to the motherboard.

    • Caution: Always remove ribbon cables by the plastic handles located on either end. Gripping a ribbon cable anywhere but the provided handles can damage the cable and render the component useless.

    Traducir

  8. PlayStation 2 Slimline IR Sensor Replacement: paso 7, imagen 1 de 1

    • Gently lift and remove the IR Sensor from its designated slot.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

8 personas más completaron esta guía.

Autor

con 2 otros colaboradores

Thomas Sullivan

Miembro Desde 10/23/13

3,927 Reputación

6 Guías creadas

Insignias: 14

+ 11 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 25

Ultimos 30 días: 94

Todo El Tiempo: 6,812