Introducción

The following steps will teach you how to disassemble your headset and install a new microphone.

  1. Flip the headset face down.
    • Flip the headset face down.

    • Squeeze both sides of the battery cover.

    • While squeezing, pull the cover up slowly to remove it.

    Agregar Comentario

  2. Locate and detatch the white connector that connects the wires of the battery to the wires of the headset.
    • Locate and detatch the white connector that connects the wires of the battery to the wires of the headset.

    Agregar Comentario

    • Use a hairdryer or heat gun to melt the adhesive along the crevice that joins the black and silver components.

    • Apply additional heat at the tip of the microphone.

    Agregar Comentario

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • After heating the headset, use the plastic opening tool to carefully pry the black cover from the headset.

    • Be aware of the two plastic connectors inside the headset. If the black cover does not come off smoothly, apply additional heat on the connectors.

    Agregar Comentario

    • Remove the microphone from the tip of the plastic.

    • You will have to lift the microphone straight up because it is held in place by a small piece of plastic.

    Agregar Comentario

    • Use the heat gun to melt the adhesive connecting the headset face to the speaker casing.

    • Use the plastic opening tool to separate the speaker casing from the headset face.

    • Add extra heat to the sides to melt the adhesive between the plastic connectors.

    Agregar Comentario

    • Slowly separate the motherboard from the rest of the headset.

    Agregar Comentario

    • Locate the microphone wires on the bottom of the motherboard.

    • Use a hairdryer or heat gun to melt the glue off of the motherboard.

    Agregar Comentario

    • Flip the device over.

    • Use a soldering iron to remove the solder that holds the wires to the motherboard.

    • For help soldering, click here.

    • The microphone piece should be completely detached from the motherboard.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order. Replace the glue and solder where they are needed.

Equipo

Cal Poly, Team 17-29, Amido Spring 2012 Miembro de Cal Poly, Team 17-29, Amido Spring 2012

CPSU-AMIDO-S12S17G29

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 10

Todo El Tiempo: 1,197