Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Use this guide to replace a broken speaker.

Partes

No se especificaron partes.

  1. Before continuing, be sure your device is powered off.
    • Before continuing, be sure your device is powered off.

    • Remove two 9mm Phillips #0 head screws from the bottom side of the speaker.

  2. Peel back the rubber feet from either side of the base.
    • Peel back the rubber feet from either side of the base.

  3. Remove four 9mm Phillips #0 head screws from the bottom of the speaker.
    • Remove four 9mm Phillips #0 head screws from the bottom of the speaker.

  4. Separate the base of the speaker from the upper housing.
    • Separate the base of the speaker from the upper housing.

  5. Remove four 9mm Phillips #0 head screws from the inside of the speaker case.
    • Remove four 9mm Phillips #0 head screws from the inside of the speaker case.

  6. Remove all cable connectors from the speaker motherboard. Remove all cable connectors from the speaker motherboard. Remove all cable connectors from the speaker motherboard.
    • Remove all cable connectors from the speaker motherboard.

  7. Remove two 7mm Phillips #0 head screws from the front panel.
    • Remove two 7mm Phillips #0 head screws from the front panel.

  8. Lift the speaker from its housing.
    • Lift the speaker from its housing.

Conclusión

To reassemble your device, follow these instructions in reverse order.

David Lennon

Miembro Desde 14/04/15

9,134 Reputación

10 Guías creadas

Equipo

Cal Poly, Team 4-5, Maness Spring 2015 Miembro de Cal Poly, Team 4-5, Maness Spring 2015

CPSU-MANESS-S15S4G5

4 Miembros

26 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 505