Repara tus cosas

Derecho a reparar

Tienda

Philips Sonicare FlexCare Spring Replacement

Escrito Por: Joanna Moraza (y 4 de otros participantes)
  • Comentarios: 0
  • Favoritos: 2
  • Terminaciones: 3

Dificultad

Moderado

Pasos

6

Tiempo Requerido

5 minutos

Secciones

1

Banderas

2

Slice and Dice

Rebanar y Trocear

Los pasos de esta guía deben ser divididos y convertidos en una serie de guías de prerrequisitos.

Better Introduction

Mejor introducción

Mejora esta guía completando o revisando su introducción.

Introducción

This guide will help you replace the spring in your Philips Sonicare FlexCare toothbrush.

Herramientas

Comprar estas herramientas

Partes

No se especificaron partes.

  1. Pull the brush head away from the handle to remove it.

    • Pull the brush head away from the handle to remove it.

    Editar

  2. Push the flat edge of a nylon or metal spudger between the seal and the toothbrush body and pry it up. Do this on each side until the seal is partially sticking out on all sides. Push the flat edge of a nylon or metal spudger between the seal and the toothbrush body and pry it up. Do this on each side until the seal is partially sticking out on all sides.

    • Push the flat edge of a nylon or metal spudger between the seal and the toothbrush body and pry it up. Do this on each side until the seal is partially sticking out on all sides.

    Editar

  4. Apply pressure to the shaft by pressing it against a firm and flat surface. Continue to apply pressure until the interior electronics are exposed.

    • Apply pressure to the shaft by pressing it against a firm and flat surface. Continue to apply pressure until the interior electronics are exposed.

    Editar

  5. Grab the circular, plastic base with the o-ring and pull it outward.

    • Grab the circular, plastic base with the o-ring and pull it outward.

    Editar

  6. Pull off the black rubber ring with a metal or nylon spudger until it clears the metal piece that holds it in place. Pull the ring out.

    • Pull off the black rubber ring with a metal or nylon spudger until it clears the metal piece that holds it in place. Pull the ring out.

    Editar

  7. Remove the spring from the rubber ring and replace it with the new spring.

    • Remove the spring from the rubber ring and replace it with the new spring.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Joanna Moraza

Miembro Desde 14/04/15

1,295 Reputación

2 Guías creadas

Insignias: 14

+ 11 más insignias

Equipo

Cal Poly, Team 4-6, Maness Spring 2015 Miembro de Cal Poly, Team 4-6, Maness Spring 2015

CPSU-MANESS-S15S4G6

4 Miembros

15 Guías creadas

0 comentarios

Agregar un comentario

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 6

Ultimos 30 días: 17

Todo El Tiempo: 2,802