Repara tus cosas Comunidad Tienda

Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement

Introducción

There is this great teardown guide for Philips Steam Iron:

Philips Pressurised Steam Generator GC8220 Teardown

I want to clarify about its temperature sensor; that if faulty, it will make problems for the steam function.

If no Philips spare part is available to you, it can be replaced with a generic from electronics component shops.

  1. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement, Temperature Sensor (NTC Thermistor): paso 1, imagen 1 de 1

    • The Temperature Sensor is attached to the bottom of the Boiler unit.

    • It is an NTC Thermistor.

    Editar

  2. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement: paso 2, imagen 1 de 1

    • It is connected to the Main PCB.

    Editar

  4. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement: paso 3, imagen 1 de 1

    • It looks like a diode. But it is a resistor that changes value with temperature.

    Editar

  5. Philips Pressurised Steam Generator Iron GC8220 and Similar Models' Temperature Sensor (NTC Thermistor) Replacement: paso 4, imagen 1 de 1

    • They come in a range of values. 10kOhms ~ 100 kOhms.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Autor

con 3 otros colaboradores

Omid

Miembro Desde 07/23/17

228 Reputación

1 Guía escrita

Insignias: 5

+ 2 más insignias

5 comentarios

With GC9640 the termistor is 226 kOhm @ 26°C.

Beim GC9640 hat der NTC 226 kOhm bei 26°C

John Maier - Contestar

My Philips GC 9245 after ironing found water on the shirts, and the iron heat is not like as hot as in the past, is this cause by the Temperature Sensor (NTC Thermistor) ?

lylim_ly - Contestar

With GC9220 model, résistance of boiler CTN : around 300k à 15°C, decreasing slowly to 160K at around 30°C, I didn’t test with other temperature.

Nico Land - Contestar

Hi all , Does anyone know how much should be the resistance on ohm of the boiler of Philips iron steamer GC9241.Thanks

Nikos Sapranidis - Contestar

Hi, my philips gc7808 do not heating up and no steam come out after beep sound after 2 mins switch on. Checked the thermaster using multimeter on continuity. Its ok. Is it possibility that temperature sensor ntc is not working hence my iron not heating up

mohd zuki - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 19

Ultimos 30 días: 74

Todo El Tiempo: 6,499