Saltar al contenido principal

Introducción

This guide will walk you through removing the old power supply for the DVD player so that a new one may be installed. This guide will also show you how to replace a blown fuse if needed.

Partes

No se especificaron partes.

  1. Philips DVP642 Power Supply Replacement, Top Panel: paso 1, imagen 1 de 2 Philips DVP642 Power Supply Replacement, Top Panel: paso 1, imagen 2 de 2
    • Remove four 7.5 mm Phillips screws on the both sides (2 on each side).

    • Remove five 7.5 mm Phillips screws on the back of the player.

  2. Philips DVP642 Power Supply Replacement: paso 2, imagen 1 de 2 Philips DVP642 Power Supply Replacement: paso 2, imagen 2 de 2
    • Lift the top panel from the back and remove. It should come off without being forced. There is a lip near the front so you many need to slide the top panel back slightly to remove it.

  3. Philips DVP642 Power Supply Replacement, Power Supply: paso 3, imagen 1 de 2 Philips DVP642 Power Supply Replacement, Power Supply: paso 3, imagen 2 de 2
    • Slide the power cord out from the case.

    • Be sure not to lose the rubber clip that is wrapped around the cord.

  4. Philips DVP642 Power Supply Replacement: paso 4, imagen 1 de 1
    • Remove the ribbon attached to the power supply by pushing the latch and gently pulling up.

  5. Philips DVP642 Power Supply Replacement: paso 5, imagen 1 de 2 Philips DVP642 Power Supply Replacement: paso 5, imagen 2 de 2
    • Now remove this ribbon wire by grasping the white head firmly and pulling up gently.

  6. Philips DVP642 Power Supply Replacement: paso 6, imagen 1 de 2 Philips DVP642 Power Supply Replacement: paso 6, imagen 2 de 2
    • Remove these two 7.5m Phillips screws and the matching set at the other end of the supply.

    • Now remove the ribbon that attaches the power supply to the motherboard by grasping the white head and gently pulling up.

  7. Philips DVP642 Power Supply Replacement: paso 7, imagen 1 de 3 Philips DVP642 Power Supply Replacement: paso 7, imagen 2 de 3 Philips DVP642 Power Supply Replacement: paso 7, imagen 3 de 3
    • Remove the last screw.

    • Pinch this plastic prong and slide the power supply up and over it. The power supply should lift free.

  8. Philips DVP642 Power Supply Replacement: paso 8, imagen 1 de 2 Philips DVP642 Power Supply Replacement: paso 8, imagen 2 de 2
    • Your power supply is now free!

    • If the fuse circled here is blown (the small wire in the glass tube is missing or broken), remove it by pinching it tightly and pulling it straight out.

    • You can find a new fuse here.

Conclusión

To reassemble your device, follow these instructions in reverse order.

7 personas más completaron esta guía.

Equipo

Cal Poly, Team 21-20, Maness Fall 2011 Miembro de Cal Poly, Team 21-20, Maness Fall 2011

CPSU-MANESS-F11S21G20

4 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 14

Ultimos 30 días: 57

Todo El Tiempo: 12,407