Introducción

In this guide you will locate screws and ribbon wires holding the motherboard in the player. After removal the motherboard itself can be repaired on the component level.

Partes

No se requieren partes.

  1. Remove four 7.5 mm Phillips screws on the both sides (2 on each side). Remove five 7.5 mm Phillips screws on the back of the player.
    • Remove four 7.5 mm Phillips screws on the both sides (2 on each side).

    • Remove five 7.5 mm Phillips screws on the back of the player.

  2. Lift the top panel from the back and remove.  It should come off without being forced.  There is a lip near the front so you many need to slide the top panel back slightly to remove it. Lift the top panel from the back and remove.  It should come off without being forced.  There is a lip near the front so you many need to slide the top panel back slightly to remove it.
    • Lift the top panel from the back and remove. It should come off without being forced. There is a lip near the front so you many need to slide the top panel back slightly to remove it.

  3. ¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  4. Locate the first three ribbon wires. Remove the ribbon wires by grasping firmly as near to the plastic head as possible and pulling. Be firm, but gentle when pulling to avoid pulling the wires off the head.
    • Locate the first three ribbon wires.

    • Remove the ribbon wires by grasping firmly as near to the plastic head as possible and pulling.

    • Be firm, but gentle when pulling to avoid pulling the wires off the head.

  5. Remove the fourth ribbon wire as in step 2. Remove the fifth ribbon wire by grasping both sides of the black clip and pulling up.  When reinserting, pull black clip up, insert the ribbon wire, and push the black clip back down. Remove the fifth ribbon wire by grasping both sides of the black clip and pulling up.  When reinserting, pull black clip up, insert the ribbon wire, and push the black clip back down.
    • Remove the fourth ribbon wire as in step 2.

    • Remove the fifth ribbon wire by grasping both sides of the black clip and pulling up. When reinserting, pull black clip up, insert the ribbon wire, and push the black clip back down.

  6. Remove the following screws: 7.5 mm Phillips screws (2) that secure the motherboard to the bottom panel. The screw on the top right will also be attached to a grounding wire, it is okay to remove this screw.
    • Remove the following screws:

    • 7.5 mm Phillips screws (2) that secure the motherboard to the bottom panel. The screw on the top right will also be attached to a grounding wire, it is okay to remove this screw.

    • Remove the 7.5 mm Phillips screw on the bottom right that attaches the grounding wire to the disc tray.

    • 7.5 mm Phillips screws (4) on outside of player near input/output plugs.

  7. Remove the motherboard by pulling it back and then up gently.
    • Remove the motherboard by pulling it back and then up gently.

    • The input/output plugs should slide out easily from the holes in the back panel.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Equipo

Cal Poly, Team 21-20, Maness Fall 2011 Miembro de Cal Poly, Team 21-20, Maness Fall 2011

CPSU-MANESS-F11S21G20

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 9

Últimos 30 Días: 44

Todo El Tiempo: 8,929