Repara tus cosas Comunidad Tienda

Philips DC320 37 Headphone or Power Jack Replacement

Introducción

Follow the procedure outlined in this guide to remove and install a broken audio or power jack.

Qué necesitas

  1. Philips DC320 37 Headphone or Power Jack Replacement, Docking entertainment system: paso 1, imagen 1 de 1

    • Pry off the four white feet with the pointed end of the spudger

    Traducir

  2. Philips DC320 37 Headphone or Power Jack Replacement: paso 2, imagen 1 de 1

    • Gently unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

    Traducir

  3. Philips DC320 37 Headphone or Power Jack Replacement: paso 3, imagen 1 de 1

    • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

    • The connectors on the panel are fragile and may break.

    Traducir

  5. Philips DC320 37 Headphone or Power Jack Replacement: paso 4, imagen 1 de 3 Philips DC320 37 Headphone or Power Jack Replacement: paso 4, imagen 2 de 3 Philips DC320 37 Headphone or Power Jack Replacement: paso 4, imagen 3 de 3

    • Carefully pull up and out the four electrical connectors and two ribbon connectors that connect the bottom panel to the dock.

    • Electrical Connectors

    • Ribbon Connectors

    • The cables do not have a lot of slack in them. Be careful not to break the connectors.

    • One wire is soldered onto the bottom panel. Be careful not to break this bond.

    Traducir

  6. Philips DC320 37 Headphone or Power Jack Replacement, Headphone or Power Jack: paso 5, imagen 1 de 1

    • Unscrew the two 5 mm Phillips #00 screws attaching white support bracket to the body of the device.

    Traducir

  7. Philips DC320 37 Headphone or Power Jack Replacement: paso 6, imagen 1 de 1

    • Unscrew the two 5 mm Phillips #00 screws from green Headphone/Power electronics board to detach from white support bracket.

    Traducir

  8. Philips DC320 37 Headphone or Power Jack Replacement: paso 7, imagen 1 de 1

    • Separate the white suport bracket from the headphone/power electronics board.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 5 otros colaboradores

Graham Rolph

Miembro Desde 04/18/13

1 Reputación

2 Guías creadas

Insignias: 2

Equipo

Cal Poly, Team 3-48, Amido Spring 2013 Miembro de Cal Poly, Team 3-48, Amido Spring 2013

CPSU-AMIDO-S13S3G48

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 1

Todo El Tiempo: 1,255