Repara tus cosas Comunidad Tienda

Petnet SmartFeeder SF10E Battery Replacement

Introducción

Use this guide to replace the battery for your SmartFeeder to get your device up and running again. This guide is also a prerequisite to access and replace the motherboard and charging assembly.

Qué necesitas

  1. Petnet SmartFeeder SF10E Battery Replacement, Battery: paso 1, imagen 1 de 3 Petnet SmartFeeder SF10E Battery Replacement, Battery: paso 1, imagen 2 de 3 Petnet SmartFeeder SF10E Battery Replacement, Battery: paso 1, imagen 3 de 3

    • Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.

    • Remove the metal tray by using both hands and pulling out the bowl towards you.

    Traducir

  2. Petnet SmartFeeder SF10E Battery Replacement: paso 2, imagen 1 de 2 Petnet SmartFeeder SF10E Battery Replacement: paso 2, imagen 2 de 2

    • Turn the bowl tray side down by using both hands.

    • Remove seven 11 mm screws by using the Phillips #1 screwdriver.

    Traducir

  4. Petnet SmartFeeder SF10E Battery Replacement: paso 3, imagen 1 de 2 Petnet SmartFeeder SF10E Battery Replacement: paso 3, imagen 2 de 2

    • Take the battery out of the SmartBowl with tweezers, avoid pulling on any wires.

    • Hold the SmartBowl down using one hand while using the other hand to remove the battery.

    Traducir

  5. Petnet SmartFeeder SF10E Battery Replacement: paso 4, imagen 1 de 2 Petnet SmartFeeder SF10E Battery Replacement: paso 4, imagen 2 de 2

    • Remove the tape, closest to the four white connectors, with your hands.

    • Keep the wires attached to the tape for easy reassembly.

    Traducir

  6. Petnet SmartFeeder SF10E Battery Replacement: paso 5, imagen 1 de 2 Petnet SmartFeeder SF10E Battery Replacement: paso 5, imagen 2 de 2

    • Trace the wires with your hands from the battery to the motherboard.

    • Detach the three-prong connector between the battery and the motherboard by pulling the white connectors with your hands.

    • Hold on to the sockets on the motherboard or you could accidentally pull off the entire assembly.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 3 otros colaboradores

Kristin Villanueva

Miembro Desde 10/08/18

370 Reputación

2 Guías creadas

Insignias: 7

+ 4 más insignias

Equipo

Cal Poly, Team S13-G7, White Fall 2018 Miembro de Cal Poly, Team S13-G7, White Fall 2018

CPSU-WHITE-F18S13G7

4 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 538