Introducción

Use this guide to replace your 12 pin connector if it is damaged and does not charge properly. When replacing the component, use a Phillips #1 screwdriver and iFixit Opening Tools to proceed with the replacement.

Partes

No se requieren partes.

  1. Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.
    • Eject the SmartBowl by pressing the button located at the front of the SmartFeeder base.

  2. Remove the food tub by twisting it counter-clockwise with both hands and lifting it up.
    • Remove the food tub by twisting it counter-clockwise with both hands and lifting it up.

    • Remove the black plastic gasket from the top of the SmartFeeder by placing your fingers on the side of it and lifting up.

    • It should come off easily.

    • Flip over the SmartFeeder by using both hands.

    • Partially open the outer case of the SmartFeeder by wedging an iFixit Opening Tool on each side.

    • Turn the SmartFeeder on its side and with one hand on the base, carefully pull out the central section.

    • Place the bottom piece of the device right-side up.

    • Remove one 10 mm screw by using the Phillips #1 screwdriver.

    • Remove the plastic retaining piece for the daughterboard by pulling it out with one hand.

    • Pull the daughterboard out of the device and remove the three-prong connectors by using your hands.

    • Hold onto the sockets on the motherboard or you could accidentally pull off the entire assembly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ashley Kim

Miembro Desde 08/10/18

172 Reputación

1 Guía escrita

Equipo

Cal Poly, Team S13-G7, White Fall 2018 Miembro de Cal Poly, Team S13-G7, White Fall 2018

CPSU-WHITE-F18S13G7

4 Miembros

5 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 4

Todo El Tiempo: 63