Saltar al contenido principal

Pentax Optio WG-2 Back Case Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. Pentax Optio WG-2 Back Case Replacement, Back Case: paso 1, imagen 1 de 2 Pentax Optio WG-2 Back Case Replacement, Back Case: paso 1, imagen 2 de 2
    • Remove all four 1 mm JIS #00 screws from the back of the camera.

  2. Pentax Optio WG-2 Back Case Replacement: paso 2, imagen 1 de 1
    • Use your finger to peel the grip off the top of the camera.

    • For best results, start from the right side of the camera, opposite the buttons.

    • Once the grip is removed, you will most likely lose the water-tight seal.

  3. Pentax Optio WG-2 Back Case Replacement: paso 3, imagen 1 de 1
    • Use the tweezers to remove the two buttons from the top of the camera.

    • The buttons may fall out while removing the grip.

  4. Pentax Optio WG-2 Back Case Replacement: paso 4, imagen 1 de 3 Pentax Optio WG-2 Back Case Replacement: paso 4, imagen 2 de 3 Pentax Optio WG-2 Back Case Replacement: paso 4, imagen 3 de 3
    • Remove the three 1 mm JIS #000 screws from the top.

    • Remove the 1 mm JIS #000 screw from the bottom.

  5. Pentax Optio WG-2 Back Case Replacement: paso 5, imagen 1 de 1
    • Carefully separate the back and the front of the camera.

    • There are three ribbon cables connecting the two boards. Be careful not to tear them.

  6. Pentax Optio WG-2 Back Case Replacement: paso 6, imagen 1 de 1
    • Use the tip of a spudger to flip up the small retaining flaps on the ribbon cable ZIF connectors.

    • Carefully pull the ribbon cables out of their sockets.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 2

Todo El Tiempo: 142