Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the metal spudger to carefully pull apart the screen cover from the case.
-
Replace the metal spudger with a plastic opening tool to hold the cover open.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the metal spudger tool to carefully loosen the rest of the cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully, pull apart the cover with the plastic opening tool.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert metal spudger into the side of the screen shown in the picture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once screen is lifted, insert plastic opening tool between the screen connector and circuit board.
-
Disconnect the screen from the circuit board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the three screws on the circuit board.
-
Remove using the J000 Philips head screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully disconnect the connector wire on the bottom left edge of the circuit board using a plastic opener tool.
-
Move apart the connector to expose the fourth screw.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the final screw from the circuit board with a J000 Philips head screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the watch to the side and use the plastic opening tool to lift up the circuit board.
-
Remove the circuit board from the case.
-