Saltar al contenido principal

Parrot AR.Drone 2.0 Motor Replacement

Qué necesitas

Resumen del Video

  1. Parrot AR.Drone 2.0 Motor Replacement, Propeller and Gear: paso 1, imagen 1 de 2 Parrot AR.Drone 2.0 Motor Replacement, Propeller and Gear: paso 1, imagen 2 de 2
    • Remove the foam body.

  2. Parrot AR.Drone 2.0 Motor Replacement: paso 2, imagen 1 de 2 Parrot AR.Drone 2.0 Motor Replacement: paso 2, imagen 2 de 2
    • Disconnect the battery by pulling the two red wires apart.

    • Remove the battery by releasing the battery retaining straps.

  3. Parrot AR.Drone 2.0 Motor Replacement: paso 3, imagen 1 de 1
    • Remove the small retaining clip using a plastic opening tool.

    • Be careful as these clips can fly off and can be difficult to find.

  4. Parrot AR.Drone 2.0 Motor Replacement: paso 4, imagen 1 de 3 Parrot AR.Drone 2.0 Motor Replacement: paso 4, imagen 2 de 3 Parrot AR.Drone 2.0 Motor Replacement: paso 4, imagen 3 de 3
    • The propeller, gear, and rod can be removed by simply lifting them off the motor.

  5. Parrot AR.Drone 2.0 Motor Replacement, Motor: paso 5, imagen 1 de 2 Parrot AR.Drone 2.0 Motor Replacement, Motor: paso 5, imagen 2 de 2
    • Disconnect the connector at the bottom of the motor assembly.

  6. Parrot AR.Drone 2.0 Motor Replacement: paso 6, imagen 1 de 1
    • Remove the three 5mm screws on the top of the motor assembly with a PH00 bit.

  7. Parrot AR.Drone 2.0 Motor Replacement: paso 7, imagen 1 de 1
    • Remove the three 5mm screws on the bottom again using a PH00 bit.

    • The three screws from the top are different from the three screws on the bottom.

  8. Parrot AR.Drone 2.0 Motor Replacement: paso 8, imagen 1 de 2 Parrot AR.Drone 2.0 Motor Replacement: paso 8, imagen 2 de 2
    • Carefully wiggle out the motor assembly out of the arm.

Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

David Hoyt

Miembro Desde 04/09/10

4,023 Reputación

43 Guías creadas

Equipo

Cal Poly, Team 25-89, Amido Spring 2010 Miembro de Cal Poly, Team 25-89, Amido Spring 2010

CPSU-AMIDO-S10S25G89

4 Miembros

63 Guías creadas

2 comentarios

are the motors different on each side?

dbksoft - Contestar

I need to know this also. replaced cross.member but did not put motors in original spots now my drone goes crazy and erratic

Steven Maloney -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 14

Todo El Tiempo: 5,675