Qué necesitas
-
-
Turn the camera off and identify the battery door located on the bottom of the camera.
-
-
-
Orient the camera so the bottom is facing up and the battery door is on the right side.
-
Remove four black screws from the bottom of the camera.
-
Remove two black screws from the right side of the camera.
-
Remove one black screw from the left side of the camera.
-
-
-
-
Remove the screen using the plastic opening tool, prying from the top.
-
Once it's lifted up, tug lightly on the large ribbon cable to detach the screen from the camera body.
-
-
Paso 9 Lens Assembly
Aviso: los pasos 9-12 provienen de una guía que está marcada como "En progreso".
-
Remove the three screws from the center of the copper plate.
-
Remove the four screws from the outer edges of the copper plate.
-
Use a plastic or metal spudger to pry the copper plate out of place.
-
-
-
Remove the seven screws surrounding the lens assembly.
-
Remove the three springs surrounding the lens.
-
Apply pressure on the front of the lens to push the lens out.
-
-
-
Remove the one screw holding the camera and the flash component together.
-
Gently pull the flash component out of the camera body.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
Un comentario
Step 7: Does not mention the HDMI port door. Make sure you account for it