Introducción

This guide will show you how to remove the top panel buttons so you can install new ones.

Partes

No se requieren partes.

Move the switch on the battery door to the Open position.
  • Move the switch on the battery door to the Open position.

  • The door will automatically swing open after you let it go.

Agregar Comentario

Push the small gray tab on the top right corner to the left. The battery will pop out slightly.
  • Push the small gray tab on the top right corner to the left. The battery will pop out slightly.

  • Keep your finger clear of the battery when it pops out.

Agregar Comentario

  • Push the memory card in and let go.

  • The memory card will pop out slightly.

  • Pull out the memory card.

Agregar Comentario

  • Unscrew the small screws on the sides of the camera.

  • The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm).

Agregar Comentario

  • Unscrew the three small screws on the bottom(#00P, 3.3mm).

  • The bottom will fall off.

Agregar Comentario

  • Lift up the bottom back cover by prying the bottom edge with the spudger.

  • Gently lift up the back cover with your hand from the bottom to the top.

Agregar Comentario

  • Lift the tabs on the ZIF connectors.

  • The ribbon cables should easily come out of the ZIF connectors.

Agregar Comentario

  • Using the spudger, pry off the top cover by gliding the spudger along the entire edge between the top cover and the front cover.

  • Be careful not to damage the cylindrical capacitor on the circuit board under the top cover.

Agregar Comentario

  • Unscrew the small screws beneath the top cover(#00P, 1.7mm).

Agregar Comentario

  • Lift the motherboard out with your hand by pushing the tabs out and pulling the motherboard up.

  • The on/off switch and the anti-shake button may fall out.

Agregar Comentario

  • The buttons are hardwired into the top motherboard board.

  • To replace the top buttons, you must replace the top motherboard.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Karissa

Miembro Desde 13/04/12

50 Reputación

8 Guías creadas

Equipo

Cal Poly, Team 6-23, Amido Spring 2012 Miembro de Cal Poly, Team 6-23, Amido Spring 2012

CPSU-AMIDO-S12S6G23

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 507