Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove rear cover by gently lifting it up from the bottom.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully lift up the circuit board, which will also lift up the screen. Do so carefully to prevent breaking the connectors.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the left side of the circuit board and open it as though it were a book.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the three connectors located on the right side of the circuit board with great caution and care. Do not pull by the cable, and be sure to pull the connector itself gently.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After separating the screen from the board, set aside the old display screen.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Close again like a book, and lay it gently into the front panel, screen facing outwards of the front panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.
-