Saltar al contenido principal

Palm Vx Screen Replacement

Qué necesitas

  1. Palm Vx Screen Replacement, Screen: paso 1, imagen 1 de 1
    • Take protective cover off of organizer.

    • Note: cover slides off like pointer pen.

  2. Palm Vx Screen Replacement: paso 2, imagen 1 de 1
    • Lay device face down on surface.

  3. Palm Vx Screen Replacement: paso 3, imagen 1 de 2 Palm Vx Screen Replacement: paso 3, imagen 2 de 2
    • Heat each side for 30 seconds individually.

    • Note: Be aware not to heat the screen, or any part to the point of damage.

    • Caution: Heating the metal case may cause burns.

  4. Palm Vx Screen Replacement: paso 4, imagen 1 de 3 Palm Vx Screen Replacement: paso 4, imagen 2 de 3 Palm Vx Screen Replacement: paso 4, imagen 3 de 3
    • Pry off each side individually using a plastic pry bar.

    • Note: Using a plastic pry bar will keep from damaging the case. DO NOT use a metal screwdriver or similar tool.

    • Repeat for front and back of PDA.

    • Note: Do not lose the green power button that may fall out.

  5. Palm Vx Screen Replacement: paso 5, imagen 1 de 1
    • Remove the screen from the plastic casing.

  6. Palm Vx Screen Replacement: paso 6, imagen 1 de 2 Palm Vx Screen Replacement: paso 6, imagen 2 de 2
    • In order to seperate the screen from the motherboard you must disconnect the ribbon attached to the screen.

    • To do this, using tweezers, flip up the cable clamp that is connecting the ribbon to the screen.

    • Once the clamp is up you can use the tweezers to gently detach the ribbon.

  7. Palm Vx Screen Replacement: paso 7, imagen 1 de 1
    • Now you must flip up the adjacent clamp as well, using tweezers like before.

    • After the clamp is flipped you can gently remove the second ribbon with tweezers.

  8. Palm Vx Screen Replacement: paso 8, imagen 1 de 1
    • Before removing the screen you must detach one more wire, the battery connector.

    • Using the tweezers, squeeze the connector attached to the wire and genlty pull.

    • Do not pull on the wire.

  9. Palm Vx Screen Replacement: paso 9, imagen 1 de 2 Palm Vx Screen Replacement: paso 9, imagen 2 de 2
    • Now that both ribbons and the wire are disconeccted, you can apply a downward pressure to the battery. You will have to carefully rotate the frame so that the battery can go through.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Will Doornink

Miembro Desde 10/04/11

11 Reputación

1 Guía escrita

Equipo

UW Stout, Team 5-4, Zhou Fall 2011 Miembro de UW Stout, Team 5-4, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G4

4 Miembros

1 Guía escrita

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 18

Todo El Tiempo: 1,904