Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Palm Treo 680 screen replacement

Introducción

This guide shows how to repair a disfunctional Palm Treo 680 LCD Screen/Touch Screen.

Qué necesitas

  1. Palm Treo 680 screen replacement, Battery: paso 1, imagen 1 de 2 Palm Treo 680 screen replacement, Battery: paso 1, imagen 2 de 2

    • Remove the battery cover by pressing on the small rectangular button located on the back of the phone.

    Traducir

    Donde puedo comprar un telefono palm

    lupem5635 - Contestar

  2. Palm Treo 680 screen replacement: paso 2, imagen 1 de 1

    • Remove the battery by pulling it out towards you.

    Traducir

  3. Palm Treo 680 screen replacement, Back Panel: paso 3, imagen 1 de 2 Palm Treo 680 screen replacement, Back Panel: paso 3, imagen 2 de 2

    • Remove the stylus in order to access the screw.

    • Remove the 27mm top-left screw using a T6 Torx screwdriver.

    Traducir

    Use a T5 Torx screwdriver instead of a T6. T6 is too big.

    Rhebakah Thomas - Contestar

    I found T5 too large as well. T4 seeems to work

    Absent Minded Professor - Contestar

  4. Palm Treo 680 screen replacement: paso 4, imagen 1 de 2 Palm Treo 680 screen replacement: paso 4, imagen 2 de 2

    • Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.

    • Remove the 27mm screw using the T6 Torx screwdriver.

    • If there is a red Palm sticker covering this screw, puncture it to access the screw.

    Traducir

  6. Palm Treo 680 screen replacement: paso 5, imagen 1 de 1

    • Remove the remaining two 27mm screws from the bottom using the T6 screwdriver.

    Traducir

  7. Palm Treo 680 screen replacement: paso 6, imagen 1 de 3 Palm Treo 680 screen replacement: paso 6, imagen 2 de 3 Palm Treo 680 screen replacement: paso 6, imagen 3 de 3

    • Turn the phone so the screen is facing the right side.

    • Use a spudger to carefully separate the back panel from the front panel to access components inside the phone.

    • Separate the covers from the left side of the device as indicated in the picture.

    • The right side contains orange ribbons that are easily damaged.

    Traducir

  8. Palm Treo 680 screen replacement, LCD Screen and Touch Screen: paso 7, imagen 1 de 3 Palm Treo 680 screen replacement, LCD Screen and Touch Screen: paso 7, imagen 2 de 3 Palm Treo 680 screen replacement, LCD Screen and Touch Screen: paso 7, imagen 3 de 3

    • Take the front the pannel and notice that the screen is attached by a piece of silver tape.

    • Using a pair of tweezers, carefully peel off this piece of silver tape.

    • Remove the screen from the front pannel.

    Traducir

  9. Palm Treo 680 screen replacement: paso 8, imagen 1 de 2 Palm Treo 680 screen replacement: paso 8, imagen 2 de 2

    • Obtain a small metal spudger and flip up the 2 tiny plastic flaps that hold the tiny orange ribbons in place.

    • Do the same thing for the other flap on the opposite side.

    Traducir

  10. Palm Treo 680 screen replacement: paso 9, imagen 1 de 3 Palm Treo 680 screen replacement: paso 9, imagen 2 de 3 Palm Treo 680 screen replacement: paso 9, imagen 3 de 3

    • Flip the screen over a 180 degrees and take off the metal piece that cushions the screen.

    • Flip the screen over another a 180 degrees and place pressure on the bottom ribbon (Where my left thumb is).

    • Slightly Pull apart the touch screen from the LCD screen by placing your thumbs where my thumbs are. DO NOT PULL THE TWO SCREENS COMPLETELY APART YET.

    • This part is tricky and might take some maneuvering and a little bit of force, but it is possible.

    Traducir

  11. Palm Treo 680 screen replacement: paso 10, imagen 1 de 3 Palm Treo 680 screen replacement: paso 10, imagen 2 de 3 Palm Treo 680 screen replacement: paso 10, imagen 3 de 3

    • Move your thumbs to the other corner of the screen and repeat the same procedure in step 9.

    • Carefully peel the touch screen away from the LCD screen.

    • Now you should have both the touch screen and LCD screen detached from one another.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 8 otros colaboradores

Maiya123

Miembro Desde 10/22/09

51 Reputación

6 Guías creadas

Insignias: 9

+ 6 más insignias

Equipo

Cal Poly, Team 6-4, Maness Fall 2009 Miembro de Cal Poly, Team 6-4, Maness Fall 2009

CPSU-MANESS-F09S6G4

4 Miembros

12 Guías creadas

2 comentarios

where can i get the new touch scree, actually my mobile has fallen down and broken the touch scree. i am a resident in India, Andhra Pradesh, Hyderabad........at Ramkote.... please give me message at chinthala.prasad@yahoo.com please

chinthalaprasad - Contestar

These are very nice instructions. They are clear and detailed for anyone to follow. Thanks for putting together the steps and sharing it.

I have not tried all steps completely yet. But will do so. I will left with probably a question what to do with touch screen. My phone has

never fallen down nor damaged. It worked perfectly well and one fine day, touch screen stopped working. In any case, I will try.

RJ

Ravi Joshi - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 2

Todo El Tiempo: 6,429