Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the battery cover by pressing on the small rectangular button located on the back of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the stylus in order to access the screw.
-
Remove the 27mm top-left screw using a T6 Torx screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger, remove the rubber rectangular cover located in the upper rear, right-hand corner.
-
Remove the 27mm screw using the T6 Torx screwdriver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the remaining two 27mm screws from the bottom using the T6 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the phone so the screen is facing the right side.
-
Use a spudger to carefully separate the back panel from the front panel to access components inside the phone.
-
Separate the covers from the left side of the device as indicated in the picture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the slim metal plate upwards until it disconnects from the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the orange ribbon that connects the screen to the motherboard.
-
Use tweezers to peel off the small piece of tape over the orange ribbon connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the spudger between the orange ribbon and black connector. Flip the black connector upwards to release the orange ribbon.
-
Using the spudger, pull the orange ribbon away from the connector to confirm the wire is fully disconnected.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully turn the phone over so the screen is face up.
-
Locate the other orange ribbon that connects the motherboard to the faceplate.
-
Slide the spudger between the orange ribbon and tan connector. Lift the tan connector up to release the orange ribbon.
-
Separate the motherboard and faceplate of the Palm Treo.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.