Introducción

This guide will help you access and replace the Treo's camera if it is no longer functional.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

Agregar Comentario

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

Agregar Comentario

Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
  • Lift the edge of the battery, separating contact points, and pull out as pictured.

Agregar Comentario

Remove the small round rubber cover on the back of the phone located immediately below the antenna.
  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

Agregar Comentario

Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver. Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver. Pull out antenna.
  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

Agregar Comentario

Pry the back cover off using a spudger or similar tool. The back cover is attached by several small clips on the inside.
  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

Agregar Comentario

Remove the two 3.75 mm screws. Pull off the logic board. Pull off the logic board.
  • Remove the two 3.75 mm screws.

  • Pull off the logic board.

Agregar Comentario

Pull the rubber ring off of the camera. Pull the rubber ring off of the camera. Pull the rubber ring off of the camera.
  • Pull the rubber ring off of the camera.

Agregar Comentario

Pry off the metal camera case. Lift up the camera, but do not remove. The connector must be detatched first.
  • Pry off the metal camera case.

  • Lift up the camera, but do not remove. The connector must be detatched first.

Agregar Comentario

Pry off the camera connector plug. Remove the camera.
  • Pry off the camera connector plug.

  • Remove the camera.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

cgood

Miembro Desde 28/10/09

116 Reputación

14 Guías creadas

Equipo

Cal Poly, Team 19-3, Maness Fall 2009 Miembro de Cal Poly, Team 19-3, Maness Fall 2009

CPSU-MANESS-F09S19G3

4 Miembros

18 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 1,961