Introducción

This guide will walk you through the steps to remove and replace the front panel on a Palm T|X.

  1. Orient the device so that the display faces forward.
    • Orient the device so that the display faces forward.

    • Remove the stylus from the right side.

    Agregar Comentario

  2. Turn over the device so that the back panel faces forward.
    • Turn over the device so that the back panel faces forward.

    • Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.

    Agregar Comentario

    • Rotate the device so that the display faces forward.

    • Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.

    • Pry along the crevice to loosen the back panel.

    • Repeat this process for the right side.

    Agregar Comentario

    • Carefully pry the back panel to open the device.

    • Be careful not to break the wire that connects the battery pack to the motherboard.

    • When reassembling, snap the back panel back into place and then insert the top cover.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Use a plastic opening tool to peel the battery pack from the back panel.

    • The battery pack is glued to the back panel so removing it may require considerable effort.

    Agregar Comentario

    • Pull straight up on the ribbon cables located on the bottom right of the motherboard to disconnect them.

    Agregar Comentario

    • Lift the mother board out of the device.

    • A weak adhesive attaches the motherboard to the device.

    • The red wire in the picture will not be attached to your device at this point.

    Agregar Comentario

    • Orient the device sideways, as shown in the picture.

    • Lightly push the front of the display to separate it from the front panel.

    • The battery in the picture will not be attached to the device at this point.

    Agregar Comentario

    • Use a T5 Torx screwdriver to remove the 7.75mm screws at the bottom of the device.

    • It may take some manipulation to remove the screws.

    Agregar Comentario

    • Lift the button and connector assembly from the front panel.

    Agregar Comentario

    • Lift the rubber buttons off the front panel.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Jake Shiraki

Miembro Desde 19/01/11

125 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 1-15, Amido Winter 2011 Miembro de Cal Poly, Team 1-15, Amido Winter 2011

CPSU-AMIDO-W11S1G15

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 2

Últimos 30 Días: 3

Todo El Tiempo: 708