Repara tus cosas Comunidad Tienda

Palm TX Battery Pack Replacement

Introducción

Outline what you are going to teach someone how to do.

Qué necesitas

  1. Palm TX Battery Pack Replacement, Back Panel: paso 1, imagen 1 de 2 Palm TX Battery Pack Replacement, Back Panel: paso 1, imagen 2 de 2

    • Orient the device so that the display faces forward.

    • Remove the stylus from the right side.

    Editar

  2. Palm TX Battery Pack Replacement: paso 2, imagen 1 de 1

    • Turn over the device so that the back panel faces forward.

    • Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.

    Editar

  4. Palm TX Battery Pack Replacement: paso 3, imagen 1 de 2 Palm TX Battery Pack Replacement: paso 3, imagen 2 de 2

    • Rotate the device so that the display faces forward.

    • Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.

    • Pry along the crevice to loosen the back panel.

    • Repeat this process for the right side.

    Editar

  5. Palm TX Battery Pack Replacement: paso 4, imagen 1 de 2 Palm TX Battery Pack Replacement: paso 4, imagen 2 de 2

    • Carefully pry the back panel to open the device.

    • Be careful not to break the wire that connects the battery pack to the motherboard.

    • When reassembling, snap the back panel back into place and then insert the top cover.

    Editar

  6. Palm TX Battery Pack Replacement: paso 5, imagen 1 de 2 Palm TX Battery Pack Replacement: paso 5, imagen 2 de 2

    • Use a plastic opening tool to peel the battery pack from the back panel.

    • The battery pack is glued to the back panel so removing it may require considerable effort.

    Editar

  7. Palm TX Battery Pack Replacement, Battery Pack: paso 6, imagen 1 de 2 Palm TX Battery Pack Replacement, Battery Pack: paso 6, imagen 2 de 2

    • Use a soldering iron to disconnect the battery wires from the motherboard.

    • For soldering instructions, you can view the Soldering Guide.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

5 personas más completaron esta guía.

Autor

con 5 otros colaboradores

Spencer Lewson

Miembro Desde 01/19/11

793 Reputación

6 Guías creadas

Insignias: 13

+ 10 más insignias

Equipo

Cal Poly, Team 1-15, Amido Winter 2011 Miembro de Cal Poly, Team 1-15, Amido Winter 2011

CPSU-AMIDO-W11S1G15

4 Miembros

7 Guías creadas

Un comentario

In step 1 - Also remove the cover hinge by sliding downwards

In step 3 - there are actually 2 crevices on the left side of the device. Use the larger, which originally held the cover hinge (the smaller crevice seems to remove the facia)

Jack - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 3

Ultimos 30 días: 27

Todo El Tiempo: 7,051