Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Push the plastic push-down handle down and pull the plastic handle straight from metal arm.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Press down on the toaster handle to access to the grabber spring located behind the large metal plate.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the large needle nose pliers to unwind the grabber spring from one side of the carriage to remove.
-
Repeat this step for the opposite side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the old spring from the toaster unit to insert new.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.