Saltar al contenido principal

Optical Drive Enclosure Faceplate

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. Optical Drive Enclosure Faceplate, Optical Drive Enclosure Faceplate: paso 1, imagen 1 de 1
    • Remove the three 3.0 mm Phillips screws from the optical bay enclosure.

  2. Optical Drive Enclosure Faceplate: paso 2, imagen 1 de 3 Optical Drive Enclosure Faceplate: paso 2, imagen 2 de 3 Optical Drive Enclosure Faceplate: paso 2, imagen 3 de 3
    • Starting from the left edge, gently pull open the optical bay enclosure.

    • Continue to pull open the two halves of the enclosure until they separate.

  3. Optical Drive Enclosure Faceplate: paso 3, imagen 1 de 1
    • Remove the two 3.0 mm Phillips screws securing the faceplate to the optical bay enclosure.

  4. Optical Drive Enclosure Faceplate: paso 4, imagen 1 de 3 Optical Drive Enclosure Faceplate: paso 4, imagen 2 de 3 Optical Drive Enclosure Faceplate: paso 4, imagen 3 de 3
    • Lift the black plastic faceplate out of the optical bay enclosure.

    • You will no longer need the faceplate or the two Phillips screws that held it in place. Set those parts aside if you ever wish to put the faceplate back into the enclosure.

    • Reassemble the optical bay enclosure without the faceplate, reusing the original three 3.0 mm Phillips screws to keep it intact.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Brittany McCrigler

Miembro Desde 03/05/12

88,913 Reputación

131 Guías creadas

Equipo

iFixit Miembro de iFixit

Staff

136 Miembros

16,582 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 724