Repara tus cosas Comunidad Tienda

Optical Bay Enclosure Dual Hard Drive Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Introducción

Universal Prerequisite for Optical Bay Enclosures #78,79,81

  1. Optical Bay Enclosure Dual Hard Drive Replacement, Dual Hard Drive: paso 1, imagen 1 de 2 Optical Bay Enclosure Dual Hard Drive Replacement, Dual Hard Drive: paso 1, imagen 2 de 2

    • Remove the plastic positioner from the optical bay hard drive enclosure by pressing in on one of the clips on either side and lifting it up and out of the enclosure.

    Traducir

  3. Optical Bay Enclosure Dual Hard Drive Replacement: paso 2, imagen 1 de 3 Optical Bay Enclosure Dual Hard Drive Replacement: paso 2, imagen 2 de 3 Optical Bay Enclosure Dual Hard Drive Replacement: paso 2, imagen 3 de 3

    • Make sure that the hard drive connectors are facing down before placing it into the enclosure.

    • Gently place the hard drive into the enclosure's hard drive slot.

    • While firmly holding the enclosure in place with one hand, use your other hand to press the hard drive into the enclosure connectors.

    Traducir

  4. Optical Bay Enclosure Dual Hard Drive Replacement: paso 3, imagen 1 de 2 Optical Bay Enclosure Dual Hard Drive Replacement: paso 3, imagen 2 de 2

    • Once the hard drive is snug, reinsert the plastic positioner while holding the hard drive against the bottom of the enclosure.

    • Reconnect any cables you have removed from the original optical drive onto the optical bay enclosure.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 5 otros colaboradores

Brittany McCrigler

Miembro Desde 03/05/12

89,011 Reputación

131 Guías creadas

Insignias: 48

+ 45 más insignias

Equipo

iFixit Miembro de iFixit

Staff

135 Miembros

16,731 Guías creadas

Un comentario

Great guide, however I think you overestimated the difficulty of it. The biggest challenge is not stripping any screws and being sure to have all sizes that you may possibly need including some that might not be standard because stripping screws is very possible. Otherwise, nice job

Rob Anthony Dire - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 247