Opening the Column in the Hamilton Galileo - Guía de reparación iFixit

Introducción

Utilize this guide to access inside the column, a step required for other guides such as replacing the power supply. For more information on opening the column, please refer to page 11-6 in the full service manual.

Qué necesitas

Paso 1 Opening the Column in the Hamilton Galileo

Opening the Column in the Hamilton Galileo, Opening the Column in the Hamilton Galileo: paso 1, imagen 1 de 1

Use a grounding cable and wrist band connected to the GALILEO or other work surface when you are working on the GALILEO.

Paso 2

Remove from GALILEO: External mains power supply, Air and oxygen supplies, Patient breathing circuit (for convenience only), Flow Sensor tubes (for convenience only).

Paso 3

Opening the Column in the Hamilton Galileo: paso 3, imagen 1 de 1

Loosen the rear panel of the column by removing the six hexagonal-drive (Allen) screws that hold it in place.

Paso 4

Opening the Column in the Hamilton Galileo: paso 4, imagen 1 de 2

Opening the Column in the Hamilton Galileo: paso 4, imagen 2 de 2

Without removing any electrical connections, open the left side of the column as wide as practical.
This exposes: GALILEO’s internal power supply, The battery fuse, The diagnostic LEDs on the power supply’s main circuit board, and the back up batteries.

Paso 5

Make sure no electrical connections are touching the column.
Make sure all green/brown grounding (earthing) cables are securely in place.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Ian Van Sciver

Miembro Desde 04/09/20

332 Reputación

2 Guías creadas

+ 2 más insignias

Equipo

Cal Poly, Team S7-G26, Paton Spring 2020 Miembro de Cal Poly, Team S7-G26, Paton Spring 2020

CPSU-PATON-S20S7G26

3 Miembros

4 Guías creadas

0 comentarios

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 114