Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.
Introducción
How to open your Link.usb Audio Interface device despite no visible screws.
Qué necesitas
-
-
Pry the rubber off the top of the device
-
All the rubber
-
Use your fingernails, then pull with your bare hands. Do no use a heat gun or prying tool as they will damage the adhesive.
-
5 screw holes will appear. Leave them alone for now.
-
-
-
-
Look at the side of the device with the metal stand
-
Take a heat gun to the two small foam pads
-
You only need to pry off the halves on the top plastic shell
-
Put scraps of glossy paper on the foam pads to prevent them from sticking on again
-
Alternatively, if you do not mind sacrificing aesthetics, you may slice the foam pads down the middle as in the picture.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
